SQM Replication Project Update 26-09-06.

Hi Everyone, Well it has been a while since my last update. A lot has been done. I have gone in a big loop but on the ride learnt a lot of information I had only guessed about. My Magnetising procedures are now giving me a good even magnetic field in the Magnets which is a big goal I have achieved. To achieve this goal I had to build a Capacitor bank and change the discharging circuit to get maximum field strength from my low resistance magnetising coils. I have been studding more of Mr William J Hooper's work and Mrs Gibson's writings about Mr William J Hooper's work. These documents are so closely aligned to Mr Sweets work there are even sentences the same between documents. Also I have gone into deeper study on the Searl effect. You will be surprised what I have come up with.

Some Pictures of the new Capacitor bank I built to magnetise the magnets. Cost is a big factor here. For higher rated Capacitors the expense quadruples and it is far to expensive for the average person to do the Magnetising.  This setup cost me a bit over one thousand dollars. It works well. Ratings are 1200v  2500uf which doesn't sound like much but it is when it is discharged into a small coil.

Below is a Trinitron Monitor I repaired to view the Magnetic field lines of the Magnets. Very handy to see the Flux Lines. The IBM monitor I had stopped working and was beyond repair.

Some changes to Medusa:

The control circuit has been changed to suit what I believe was happening in the Video with Mr Bearden and Mr Sweet.

I have used a transformer in the circuit to the Conditioning coil. More info on the transformer coming soon once I have tested it further.

The Control circuit is pretty much a very basic amplifier to amplify a triggering sine wave at desired frequencies determined by a Oscillator.

The below picture is a copy of the wave form of a picture from the Searl Effect Website. Like is explained in the Gunner Sandberg papers these waves never go into a Negative state even though a AC coil is used with DC coils.  

This Picture is from the Rex Research Website. The picture is claimed to be from Mr Sweet. I believe it very possibly is. Certainly there is a similarity between the two wave forms. The above is longer and more sustained. The below is much shorter and is timed slightly different in the discharge. This timing difference would be to try to stop the SCR from latching which I am very familiar with. 

Next we come to the Spin of particles and how spin is so closely aligned to Magnetism. Spin flipping is important here and Magnetic moments of these particles.

Something shown very clearly in the video with Mr Sweet and Mr Bearden is the resonance of the Magnet. As explained this can vary, very slightly between Magnets. I did some experiments and the same resonance is achievable with Neodymium Magnets. The same affect. So the affect is not due to materials in the magnet. The blade waves, fanning air, as Mr Bearden put it. The blade only waves at this frequency.  I strongly believe this is atomic resonance at low Frequencies.  Just how and why is this so. On investigation and having studied some of Mr Nikola Tesla's work I remembered that Mr Tesla said there was a frequency of the Earth. It was explained that at around 7 Hz the Earths resonance could be found. This got me back to thinking about the magnets and the Magnetising process which took me a few months to get right. I speculated some and thought what if the magnets were superimposed with the Earths Resonant frequency when magnetised and the reason it varied was that the resonant frequency may be different at different points on the Earth, or it could fluctuate in its frequency?

This would explain Mr Searl's Conditioning very well, it would also explain the above Wave Form of Mr Sweets. This would also explain the fact that if the magnets were heated above the Curie Temperature and left to cool in an AC field that the magnet should retain some of the AC Field!!! The AC Field would need to be a nice sine wave or it may not stick though from early estimations. As yet I have not been able to achieve this.

I also learnt a lot magnetising the magnets. A lot about coils, the discharge into coils and most importantly the steps in magnetising the magnets successfully. As some more testing I heated some Neodymium Magnets to see the Domains loosen and the Magnetism disappear at the Curie temperature. This is amazing to see. If you ever get a chance get yourself some small Neo’s and try heating them on a element on your stove with a metal rod or bar stuck to it. You will see the magnetism just disappear. To try to explain it in words is difficult but it is like the Magnet has been released from its grip on the Aether flows in free space. Or like a strong wind blowing you on the street and then all of a sudden it stops.  Calm. The reverse is true for Magnetising the magnets. They are calm and then like being close to a lightning bolt the Capacitor is discharged into the coils and this almighty force HITS the Magnets and the wind starts. The Aether wind that is.

In the last 20+ months I have learnt a lot and I really do think I have a fairly good grip on Magnetism. It is different from other forces and because of its presence but the difficulties in seeing a visual representation it is difficult to get an idea about. Mr Sweet said in one of the documents out there, "Magnetism is not a property of the Magnet, It is a property put into the Magnet when Magnetised."

This must mean that the Conditioning of the magnets is a Waving of the Aether Wind at the desired frequency and this is to be done either at Curie Temperature, or, at or near the Magnetising field strength, or possibily a combination of both.

I have had a lot of help with ideas and being able to bounce thoughts off a couple of good mates really helps to. Thanks Dale and Dave.

Well more coming soon as always.

_________________
To reach new horizons...