The perpetual Motion
Energy Device is a push
pull device that uses
NEODYMIUM IRON BORON
- NdFeB -
Magnet poles to attract,
repel and balance the
spinning Secondary
Magnet Hive. The
secondary Magnet Hive is
housed top and bottom by
two speaker magnets to
balance the vertical
spinning Secondary
Magnet Hive. The central
magnetic Main Magnet
Hive is stationary and
is used also to balance
this device vertically
or out side ways from
the device. Two more
Speaker magnets are used
top and bottom of the
device to stabilize the
Secondary spinning
Magnet Hive in the
middle and to keep it at
a stationary height.
These magnets are
suspended on the Main
Magnet Hive vertical
axis Aluminum rod at the
center of the device.
This is an extremely
simple device to build
and will cost a minimal
amount to build also.
It consists of:
1/ Five
Segment/Arc Magnets
at width 41mm x
height 44mm with a
radius of 29mm and
with a South inward
face.
2/ Nine Segment/Arc Magnets
at width 35.5mm x
height 54mm with a
radius of 42mm and
with a North inward
face.
3/ Five
Segment/Arc Magnets
at width 46mm x
height 54mm with a
radius of 60mm and
with a South inward
face.
4/ Five Ring/Speaker
Magnets at Diameter
86mm x height 15mm
Central Hole
diameter 32mm
5/ Some Engineering from
your local Metal
Workshop.
All of which can be
obtained from:
Yuxiang Magnetic
Materials Ind. Co. Ltd
Engage in Chinese
Magnetic Materials
project
www.magnets.com.cn
More detailed
instructions coming
soon. This device is in
very early experimental
- development stages and
may change at any time.
Already we have had some
very surprising results
in the early stages of
this device and hope to
soon get a substantial
electrical output as in
the above design.
This is a subject that
has been debated for
many years and is just
starting to be taken
seriously now. Free
energy devices have been
built and publicized but
seem to fade out of
existence as soon as
they start to come in to
the public eye. Devices
that are currently,
widely known, put out
more energy than they
need to run. This is
commonly known as C.O.P:
Coefficient of
Performance. This
technology is here now
and in the future (Not
to far away, even closer
if this subject was
adequately funded) will
run your house, car,
boat and so on and so
fourth, this device will
need no input, being
Petroleum or battery's
and produce great
amounts of Output.
Tom Bearden's web site
has a detailed
independently replicated
reconstruction process
of the MEG and
information about the
MEG (Motionless
Electromagnetic
Generator) working with
measurements on the
output. We are not yet
at that stage. The MEG
can be Close looped and
run by it self, needing
only input to start up.
These are just some of
the most popular but
there are many more.
Most important, I think,
is to remember that In
the past all of these
devices have been
produced in the home by
people like you and I.
Note: this project is
now redundant and the
SQM Replication project
is top priority.
