video consisted of: Two coils, One large conditioning coil seen
in the picture on the right, and one smaller coil that is inside
the larger coil that sits at the bottom (no# 15 gauge 4 Ohms). The
smaller coil that sits at the bottom of the larger coil is powered
by a wave tech oscillator through a 100 watt audio amplifier. An
SCR that is triggered by a Variac that powers the Larger conditioning
coil with a 1600uf DC Capacitor (RC Time constant is triggering
the capacitor with the variac. (T = R x C)( T= 60 Hz). There is
a rectifier that seems to be used to change from AC current to DC
current. There does not seem to be any current smoothing circuitry.
T = R x C 1/60 of a second = 16.6666667 milliseconds (60 Hz) Capacitance
= 1600 uf Resistance = 1.4166 Ohms General conditioning procedure
in the video: The procedure is as follows. The magnet is placed
on top of the conditioning coil and bought into resonance by the
small coil at the bottom of the large coil. This is done by tuning
the Wave Tech oscillator down to between 8 Hz and 13 Hz. Then the
60 Hz is bought up to full power to the Conditioning coil. The same
is done with the second magnet. The ends are marked and kept in
line with the earths magnetic field. The magnets are then placed
together on the holder (Aluminum rectangular tube with two inches
gap to keep the magnets apart ) in attraction mode with the ends
in the same direction when they were marked. The magnets are then
placed in side the large conditioning coil at right angles to the
magnetic field and again in line with the earths magnetic field.
The small resonant coil is still at the approximate 13Hz resonance
and again the conditioning coil is bought up to full power at 60
Hz. In a nut shell that's it.
This picture is of the SQM running and outputting 500 Watts of output power.
This picture is of the conditioning setup in the Tom Bearden / Floyd Sweet video.